|
|
#33
08-09-14, 10:29
|
|||
|
|||
Dale, you are lucky in that you have no gear lever gate, so you can (within reason) have the front /rear orientation where you want it.
(just plot where the holes go along the tube (measure from the end), and drill new holes, at 90 degrees to the old ones) Use a V block to drill the holes, or drill one hole for each bolt, put the U.J. part into the tube, and use the U.J. part as a drilling guide. Does anyone have one of those parts books (with the missing page 13) that can check if there are more than one option for the various parts.
__________________
Bluebell Carrier Armoured O.P. No1 Mk3 W. T84991 Carrier Bren No2.Mk.I. NewZealand Railways. NZR.6. Dodge WC55. 37mm Gun Motor Carriage M6 Jeep Mb #135668 So many questions.... Last edited by Lynn Eades; 08-09-14 at 10:45. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Vic rail 2225 | colin jones | The Carrier Forum | 109 | 13-07-13 15:15 |
| My GM engine number when was it build?? | 8threcce | The Restoration Forum | 7 | 09-01-12 08:39 |
| Iltis carb re-build kit | servicepub (RIP) | Post-war Military Vehicles | 2 | 15-05-11 22:33 |
| How To Build A 2/5 Sherman Tank | T.J. | The Armour Forum | 1 | 16-01-08 11:17 |
| Pssst... want to build a gun tractor? | Keith Webb | The Softskin Forum | 12 | 16-07-04 00:13 |
Threaded Mode