1939-41 Ford Radiator help needed

[Mrs Vampire]

I am in need of a spare so thought the best bet was to get an aluminium replica made. I am going to draw up mne so will send dimentions as soon as I can .\

[leo tomaiolo]

don't know if this helps, but i saw this awhile ago. my 41 ford with the marmon conversion uses the same radiator and shroud as the standard 2 wheel drive frame. that's for a standard production cab.there are two different types of radiator that i've seen a early low and a late high style. early one's split and the late has no hole (split) i have both type's if you still need dimensions let me know.

[cliff]

Originally Posted by leo tomaiolo

i have both type's if you still need dimensions let me know.

Hi Leo. Yes I still need the correct sizes of the radiators. I had to shelve my project for a while but have got it on the table again now.

Many Thanks

[jack neville]

I will measure mine and send you some photos of the shroud Cliff. You are correct they are about 4" taller in the Aussie MH models

[cliff]

Originally Posted by jack neville

I will measure mine and send you some photos of the shroud Cliff. You are correct they are about 4" taller in the Aussie MH models

Thanks Jack I appreciate your help.

[leo tomaiolo]

when you say that the shroud is 4" taller is that because the fan went from being mounted on the crank, to being mounted to the generator bracket? or does the aussie marmons use a special made shroud? does your radiator sit on the frame crossmember or does it sit between the frame rails and hang down a bit? will post some picts and dimensions this weekend.

[leo tomaiolo]

here's what i got first the 41 radiator.note all dimensions in inches. overall height 28.75", overall width 22.5", overall thickness 3.125". core height 22.5" core width 21", core thickness 3". 3 rows of tubes in core. top inlet pipes 10.25" center to center. bottom inlet pipes 16.25" ctc. mounting ears 5.5" from bottom of lower tank.