CMP restoration tools

[lynx42]

Originally Posted by Ryan

Thought a thread about the tools we need and buy to help us restore our Blitz's may come in handy.
This might be a good spot to show your home made tools that have made that task a lot easier too.

A good gantry is also high in the needs list. Here I have the Canadian Scoutcar,Ford Lynx Mk.III* hull hanging high before fitting onto the chassis. Lynx Engine in and Hull on 105.jpg
Two chain pulls worked a treat off the gantry and another one on the No.7 crane set at the rear was all that was needed to maneuver the hull down onto the chassis.

A set of go-jacks enabled the chassis to be moved into position.

Can you see a Blitz there as well?

Regards Rick.