|
|
|
|
#1
02-12-14, 11:28
|
|||
|
|||
Does any of you have a rearlight assembly as on the attached drawing? I never saw it but this should be valid for Universal Mk.II and Mk.III and I think that I have exactly this on my carrier (well remains of this).
As seen on the attached picture (will send better one evening), there are two diagonal holes on the backplate which, I suppose, are for mounting of the toggle switch box and both lights. On my carrier also back section of the wiring pipes survived so as the clamps pos. 74 and 61. So I think that switch box should be mounted on the inner side of the backplate with rear lamp (left on the drawing) facing backwards just out of the the backplate and axle flooding lamp (right on the drawing) facing under the vehicle. Im I right?  And one more stupid question - what is the exact purpose of the axle flooding lamp? Thank you!
__________________
UCw Mk.III 
|
|
#2
02-12-14, 16:02
|
|||
|
|||
|
Quote:
__________________
UCw Mk.III
|
|
#3
02-12-14, 22:57
|
|||
|
|||
|
Better picture
__________________
UCw Mk.III
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Wanted: toggle switches for cab 11 or cab 12 dash panel | Lynn Eades | For Sale Or Wanted | 6 | 25-10-12 21:04 |
| repro toggle switch plates | David DeWeese | For Sale Or Wanted | 0 | 12-07-10 02:38 |
| Ball Handle Toggle Switch | Bob Moseley (RIP) | The Restoration Forum | 0 | 08-07-10 09:35 |
| Cab11/12 fuel gauge change toggle switch | aj.lec | For Sale Or Wanted | 2 | 17-05-10 20:55 |
| Bakelite Toggle Switches | Bob Moseley (RIP) | The Restoration Forum | 11 | 27-01-09 10:30 |
Hybrid Mode
