|
|
|
|
#1
19-04-15, 12:27
|
||||
|
||||
You also need a milling machine as well.
|
|
#2
23-04-15, 11:44
|
||||
|
||||
|
I have done my floor plate and have made some of the Vickers ammo and parts floor holders.
|
|
#3
23-04-15, 11:46
|
||||
|
||||
|
I would assume that these would also be in the NZ carriers as well.
|
|
#4
23-04-15, 15:51
|
||||
|
||||
|
SA rail
The vicker's box mount in a SA carrier are the same but very different .
__________________
Euan McDonald 4? C-GT (Aust) #8 44 C-GT (Aust) #9 42 Jeep, Trailer Aust 3 Welbike MK2 complete Welbike MK2 inconplete under resto C15A x3 C60S x1 ex ambo F60L x3 LP2a carrier SAR #4993. Trailer No27 Limber Trailer, Cario cargo Trailer, Pontoon semi Wiles Cooker 2 wheeled (jnr)
|
|
#5
26-04-15, 07:02
|
||||
|
||||
|
My gear change was 90 deg out so it is by far better to cut the pipe, bevel and reweld. Apart from being a quick repair, drilling new holes at 90 deg only leaves about 30% of material left. This way you are still using exactly the same holes. The front it almost complete apart from the clutch and accelerator rods and the cover.
|
|
#6
30-04-15, 10:53
|
||||
|
||||
|
The front is just about complete. I just made a few steering rods and some other work in the engine area.
|
|
#7
02-05-15, 10:28
|
||||
|
||||
|
I had a good pattern of the other cam plate cover which also incorporates the battery base holder. These parts are made out of 3mm.
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
