|
|
|
|
#1
23-04-15, 11:46
|
||||
|
||||
I would assume that these would also be in the NZ carriers as well.
|
|
#2
23-04-15, 15:51
|
||||
|
||||
|
SA rail
The vicker's box mount in a SA carrier are the same but very different .
__________________
Euan McDonald 4? C-GT (Aust) #8 44 C-GT (Aust) #9 42 Jeep, Trailer Aust 3 Welbike MK2 complete Welbike MK2 inconplete under resto C15A x3 C60S x1 ex ambo F60L x3 LP2a carrier SAR #4993. Trailer No27 Limber Trailer, Cario cargo Trailer, Pontoon semi Wiles Cooker 2 wheeled (jnr)
|
|
#3
26-04-15, 07:02
|
||||
|
||||
|
My gear change was 90 deg out so it is by far better to cut the pipe, bevel and reweld. Apart from being a quick repair, drilling new holes at 90 deg only leaves about 30% of material left. This way you are still using exactly the same holes. The front it almost complete apart from the clutch and accelerator rods and the cover.
|
|
#4
30-04-15, 10:53
|
||||
|
||||
|
The front is just about complete. I just made a few steering rods and some other work in the engine area.
|
|
#5
02-05-15, 10:28
|
||||
|
||||
|
I had a good pattern of the other cam plate cover which also incorporates the battery base holder. These parts are made out of 3mm.
|
|
#6
02-05-15, 10:33
|
||||
|
||||
|
The other side of the battery base is now made and welded in place.
All the mounting blocks for the fuel tank supports were pretty ordinary so the easiest way is to cut them all off, make new ones and weld them in.
|
|
#7
02-05-15, 10:39
|
||||
|
||||
|
Here I made a set of press tooling to make the clutch and accelerater tunnel cover. I have 1 reasonable one left but I am going to keep this as a pattern.
This is just the bottom part of the die.
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
