|
|
|
|
#1
06-09-15, 05:10
|
|||
|
|||
Looks quite interesting. How does the exhaust pipe (that goes to the rear) stay in this casting, Lynn? The ones I've got for my LP have holes for a clamping bolt.
__________________
1967 Land Rover Plant Repair Vehicle 1941 Matchless G3L 194? Wiles Junior Trailer 1941 Morris Commercial CS8 
|
|
#2
06-09-15, 07:31
|
|||
|
|||
|
Hi Alex, I'm not sure because the pipe will go right in and half block the inlet.
maybe the two clamp plates for the pipe guards under the floor are enough to locate the pipe. I have thought about tacking an extra piece of tube to the outside of the pipe that will butt up to the casting, or a stop either side of one of the clamp plates.
__________________
Bluebell Carrier Armoured O.P. No1 Mk3 W. T84991 Carrier Bren No2.Mk.I. NewZealand Railways. NZR.6. Dodge WC55. 37mm Gun Motor Carriage M6 Jeep Mb #135668 So many questions....
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| carrier exhaust boxs | kevin powles | The Carrier Forum | 25 | 02-09-19 02:25 |
| For Sale: Carrier Exhaust system | kevin powles | For Sale Or Wanted | 1 | 13-07-15 12:40 |
| Carrier Rad Elbow Question | Bruce Parker (RIP) | The Carrier Forum | 15 | 02-06-15 09:02 |
| Wanted: Carrier exhaust manifolds - both V8 | Jim Burrill | For Sale Or Wanted | 2 | 21-02-13 16:32 |
| radiator overflow brass elbow. | kevin powles | The Carrier Forum | 4 | 28-05-11 05:58 |
Hybrid Mode
