![]() |
|
#1
|
|||
|
|||
![]()
Jordan,
That is a sharp looking cover for that box! Stewart |
#2
|
|||
|
|||
![]()
So Jordan, are you going to cut holes in it for the WIRE-3 fittings?
(I cringe as I say that) |
#3
|
||||
|
||||
![]()
I'm glad I got one way back when you had a run of them made. Bruce I will most likely be putting some small holes in for the wire-3 fittings. But all in good time.
I spent a bit of time tonight taking all of the canvas racks apart and the various rifle and headset clips. I'll start sandblasting them this week. For the box my plan is to cut off the side, fix the floor/frame sheet metal. Get it sandblasted and then make new sides. Oh lots of work, but it's all for a great cause.
__________________
Jordan Baker RHLI Museum, Otter LRC C15A-Wire3, 1944 Willys MB, 1942 10cwt Canadian trailer |
#4
|
||||
|
||||
![]()
lucky guy, I saw the recovery video, super rare item, but also great that yours will help others with their trucks, more wireless trucks coming back to life,
|
#5
|
|||
|
|||
![]()
From Bob to Bob
__________________
Bob Carriere....B.T.B C15a Cab 11 Hammond, Ontario Canada |
#6
|
|||
|
|||
![]()
Bob.
Luca Giovanetti, in the For Sale Forum. I think the post went up in the last 24 hours. I seem to recall Jordan has the original plates for his Chev. David |
#7
|
||||
|
||||
![]()
Started working on the left fender today. It was a bit beat up and no longer had the nice curve to match the right side one. I traced out the right side curve some plywood to act as a guide while fixed the fender. As the metal had been stretched and warped I have had to cut it so that it would bend. It is slow work but it should get it back close to the original shape.
__________________
Jordan Baker RHLI Museum, Otter LRC C15A-Wire3, 1944 Willys MB, 1942 10cwt Canadian trailer Last edited by Jordan Baker; 12-09-16 at 21:28. |
![]() |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
1944 C-15A-Wire-5 Restoration | RichCam | The Restoration Forum | 706 | 18-05-23 02:43 |
Sold: 1944 Chev C15A Wire-3 | Don Dingwall | For Sale Or Wanted | 11 | 02-04-15 23:26 |
What was once 2, is now 1. (C15A-Wire-5) | RichCam | The Softskin Forum | 3 | 30-12-11 22:49 |
photos needed for c15a wire 3 van body | jason meade | The Softskin Forum | 5 | 10-08-11 06:29 |
Wire loom for C15A Cab13 | Jordan Baker | The Restoration Forum | 19 | 28-08-06 03:42 |