![]() |
|
#1
|
|||
|
|||
![]()
Andrew
Nice job. I have a set of 11.00 - 16 NDT pretty worn but still legal and not too old if you want them free in Brisbane. Regarding oil pressure. I took a 1945 Chev ute with Motto from Istanbul to Normandy and during the preparation was alarmed by low oil pressure. Changed gauges to eliminate error. Once the vehicle got hot it would run at around 7psi if you let the revs drop say labouring up a hill it would go back to zero. Did the whole trip and it is still driving back here in Australia trotting along now at 5psi 10 years later with no problems. I started a serious investigation on the 216 motor. 1. Factory recommended hot oil pressure for a new vehicle 13.5 lbs @ 2621 rpm ! I am sure this weird number is a result of the Owner's Manual Editors asking what oil pressure should the driver look for at 30mph and the engineers could not help themselves and converted it to engine rpm at that speed in the more technical specificatons. 2. GM did not want to put oil pressure gauges in the 216 military Chevrolets because people became alarmed but the Army insisted. 3. I have looked in numerous manuals for vehicles fitted with 216 motors and under oil pressure (if mentioned at all) the best I can find find is "indicating" 4. One source discussed the possibility that gauges reading double what they should were fitted to some vehicles to make people happy - great idea but true or not? People get confused with 235 and Blue Flame motors that ran at normally expected oil pressures. So, if your new engine sets off at 25 dead cold and drifts down to 12 or 14 hot you are on the money. The oft repeated myth that 216 motors ruin the front big end because when going up hill the oil goes to the back and it does not get fed by the "splash" feed is just that - an old wive's tale. Many people believe "splash feed" means the cranks going into the oil in the sump each turn. If they did that the motor would shake itself to bits. The big ends are fed by small sprayer pipes directed on each journal, up, down or sideways all the journals receive the same oil. The mains get the benefit of direct gallery oiling from the huge pump pressure and, as Dave says above, a few drops manage to stagger to the top of the engine to oil the cam and rockers.. Lang Last edited by Lang; 25-10-16 at 01:30. |
#2
|
|||
|
|||
![]()
G'Day Lang,
Thanks for your tyre offer (pm sent). Coincidentally Motto called in here two days ago on a camper van tour of New Zealand and we gave him a guided tour of our LRDG truck and workshop. Your comments about Chev 216 oil pressure are interesting. Our motor runs at 15 to 18psi when cold and we have not yet run it hot to see what happens then. But as the long-time owner of a Model A Ford pickup truck ![]() |
#3
|
|||
|
|||
![]()
Here are the tyres. 9.00-16 alongside for size comparison. They are not WW2 NDT but a sort of cross between NDT and Chevron.
Lang |
#4
|
|||
|
|||
![]()
Our man collected the Aussie tyres yesterday - thanks Lang! All we have to do now is get them across the ditch
![]() We have made more progress with the truck lately and now have the rear body permanently attached. On Tuesday we went for a short drive to test the brakes (see pic) and we are pleased that they work well. We are determined to display our Chev at the annual Armistice Day commemorations at Lake Karapiro on 12th and 13th November. She is not yet road-legal so we will take her over there on the back of a low-loader truck. We still have a lot of last-minute jobs to finish before then and even when they are finished she will still not be complete. For example there is still no proper petrol tank under the seat, no parking lights, no blackout light, no external condenser, no sand channels, bush bar, tail-gate chains, tool boxes, can-holders, folding aero-screens, greedy-boards, gun-mounts - the list seems endless. But we are determined to get her to Karapiro come what may! |
#5
|
|||
|
|||
![]()
On Saturday we took "Te Aroha III" to the annual Armistice Day display at Lake Karapiro, where we joined up with the other LRDG enthusiasts in jeeps and Chev 1533X2 trucks like ours. It was a great day and the culmination of six years hard work by our team. Brendan O'Carroll, author of "Kiwi Scorpions" and other well-known LRDG books was there too - that's him standing at left-centre in Arab head-dress (next to David Sterling of SAS fame!). Later we re-enacted a battle involving the LRDG and the Afrika Korps using large amounts of blank .303 ammunition, with our position being reconnoitered by a genuine Feisler Storch spotter plane. Our truck performed very well and we look forward to similar occasions in future.
|
#6
|
||||
|
||||
![]() Quote:
Kind Regards Lionel
__________________
1940 Chevrolet MCP with Holden Built Cab (30 CWT). 1935 REO Speed Wagon. 1963 Series 2A Army Ambulance ARN 112-211 Series III ex-Military Land Rovers x 2 Last edited by Lionelgee; 15-11-16 at 13:01. |
#7
|
|||
|
|||
![]()
Yes, the very same plane. Not sure who owns it, but it was also at a previous Karapiro event. It hovered over us, hardly even moving, informing the enemy of our movements. Heavy AA fire from our trucks seemed not to worry it at all
![]() In Libya during WWII the LRDG were being followed and watched by a Storch when it landed to confer with some enemy officers on the ground. Two LRDG men hiding nearby, ran over capturing the Germans and burning their plane before they knew what hit them. |
![]() |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
LRDG-Chevy or not? | Kuno | The Softskin Forum | 12 | 24-12-19 20:14 |
Dash of the Chev 30cwt LRDG | Sean Dunnage | The Softskin Forum | 2 | 05-05-12 12:02 |
LRDG Chev | Richard Coutts-Smith | For Sale Or Wanted | 2 | 09-10-07 22:24 |
LRDG Portee | Paul Ramsden | The Softskin Forum | 3 | 09-11-06 20:20 |
LRDG Chev on E-bay | Tony Smith | For Sale Or Wanted | 12 | 01-10-05 20:20 |