An Introduction: Chris Collins and Morris Tilly Project

[jack neville]

I am at the stage where I want to install the B pillars and attach the rear chassis rails and floor. I clamped the B pillars onto the chassis and hung the drivers door on its hinges to make sure it lined up properly. It did almost but not quite. The B pillar hinges have no adjustment but there is about 6mm adjustment on the door hinge. The best way i think will be to position the door and adjust it to the opening as best I can lining up the gaps and catches before I weld the B pillar. To make it a bit easier I decided to strip the doors now and lighten the load. This drivers door is in very sound condition including very good interior timber trim. Under the dilapidated bailey channel is a very good sample of original paint color, although Chris is going with a mid war brown for these restos.