|
|
#24
05-01-17, 05:51
|
|||
|
|||
From looking at your pictures I would say you need different water pump pulleys as shown in this picture which stick out further as you can see the pulley groove is almost flush with the end of the shaft compared with the offset ones you have now.
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Lynx Hull number? | James Gosling | The Armour Forum | 3 | 17-08-15 08:28 |
| At last here are some photos NZ LP hull | Lew Skelton | The Carrier Forum | 12 | 29-04-11 10:22 |
| Hull # | gary_bath_jr | The Carrier Forum | 5 | 12-07-10 20:31 |
| Welded hull | martyn | The Carrier Forum | 14 | 15-03-10 13:02 |
| UC Hull | Richard Coutts-Smith | The Carrier Forum | 14 | 08-04-08 01:25 |
Threaded Mode