|
|
#11
16-05-17, 18:08
|
|||
|
|||
Choke linkage
Guys,
The carburetor on my Lynx 11 is a Ford 21-29, which is reverse mounted compared to conventional engined CMPs. My original choke linkage was missing and my current setup is reversed to what it should be. Works, but the cab control knob is pulled out when it should be flush and vice versa. I do have the second original piece of the choke linkage. Would anyone out there have a good picture of the piece that I have identified with the yellow arrow. and would be willing to make a tracing of it ? Thanks, Peter 2017-05-16 09.34.11_LI.jpg 2017-05-16 09.35.21.jpg 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Lynx Hull number? | James Gosling | The Armour Forum | 3 | 17-08-15 09:28 |
| At last here are some photos NZ LP hull | Lew Skelton | The Carrier Forum | 12 | 29-04-11 11:22 |
| Hull # | gary_bath_jr | The Carrier Forum | 5 | 12-07-10 21:31 |
| Welded hull | martyn | The Carrier Forum | 14 | 15-03-10 14:02 |
| UC Hull | Richard Coutts-Smith | The Carrier Forum | 14 | 08-04-08 02:25 |
Threaded Mode