|
|
|
|
#1
13-02-18, 10:22
|
|||
|
|||
If I remember correctly the slotted end takes a 5/16" clevis pin, and the fixed end is a 3/8" dia. clevis pin.
__________________
Bluebell Carrier Armoured O.P. No1 Mk3 W. T84991 Carrier Bren No2.Mk.I. NewZealand Railways. NZR.6. Dodge WC55. 37mm Gun Motor Carriage M6 Jeep Mb #135668 So many questions.... 
|
|
#2
17-03-18, 14:49
|
|||
|
|||
|
BOGIE dimentions
How will the BC behave with such wheel dimensions?
thanks
__________________
 4x1om Israel Berko
|
|
#3
17-03-18, 15:21
|
|||
|
|||
|
I doubt the carrier will even notice the different size wheels. I am working on a carrier that belongs to a local infantry battalion. When it was put together back around 1977, they used several front idler wheels in place of the normal roadwheels. Only problem was they did not change the inner bearings over to the roadwheel size. This ended up causing some wear on the inner support arm, but even so, the carrier functioned just fine.
|
|
#4
17-03-18, 15:30
|
|||
|
|||
|
Israel, I would personally use 20´ wheel at the rear boogie assy.
__________________
UCw Mk.III
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| For Sale: Bren Carrier Seat Backs (Restoration Req'd) | B. Harris | For Sale Or Wanted | 2 | 08-02-16 15:33 |
| Buried Mk 1 Bren carrier restoration | derk derin | The Carrier Forum | 47 | 30-01-10 18:27 |
| Bren Carrier Restoration | delgriffith | The Restoration Forum | 0 | 23-11-06 01:40 |
| Bren Gun Carrier/Carrier LP2A Steering Wheel on eBay | Hanno Spoelstra | For Sale Or Wanted | 0 | 29-05-05 22:39 |
| Carrier Restoration | Richard Notton | The Carrier Forum | 9 | 01-02-04 22:06 |
Hybrid Mode
