Wanted: Carter Carb

[Bruce Parker (RIP)]

It's a Carter W1 you're after, right?

[gary_bath_jr]

Hey Bruce

I am not sure, I see that advertised on a few sites that sell the old stuff but the Manual says 387-S so...

I attached the picture from the manual not sure if you tell much from it.

[Bob Carriere]

Lots of old cores for sale if you can find a carb shop to rebuilt it for you.....Also a few rebuilt at $400 to $450....ouch!!!!

Good Luck

Cheers

[Bruce Parker (RIP)]

Originally Posted by gary_bath_jr

Hey Bruce

I am not sure, I see that advertised on a few sites that sell the old stuff but the Manual says 387-S so...

I attached the picture from the manual not sure if you tell much from it.

It's a Carter W1 you're after, they were used on CMP Chevs and most of the civilian 216s in the late 1930's. There are a bunch of them out there with a 'climate control' (basically and automatic choke) that are post war commercial Chev but would do in a pinch.

I did see those pricy rebuilds on e-bay. I wonder if that's because there aren't any rebuild kits left?

[gary_bath_jr]

So..... I managed to find a carb on Ebay out of Winterpeg, he wanted 11.99 USD for it so I bought it, a rebuild kit is around 100 bucks, I am hopimg that after a clanup and rebuild that I will have a decent working carb for a heck of a lot less than 500.

Now I need to make a puller to get the pulley off my water pump.

Thank you for all the info and the email (Harry).

Gary

[Harry Moon]

I think you will find the pulley spot welded on to the water pump, be careful.

[gary_bath_jr]

Hey Harry

I have checked the pump and it does not appear to be welded, at least on the outside of the pulley, I would assume that that is where it would be welded if it was. The pulley would go on last and then get welded correct?

We did try using a puller that uses 2 of the four holes and added heat but it would not budge, I am going to make a puller that has 4 holes like the manual shows.

searching online so far water pumps with a core charge are like 350 US so lets see if I can get this one apart lol.

Gary

[r.morrison]

Hi Gary....long time no talk. Anyway, if this is of any use to you for your carbureter "rebuild", your more than welcome to have it. I had it for a while and I don't know if it is for your carb. Maybe some of the guys can comment. I can mail it to you.
Good luck.....Robert