![]() |
|
#1
|
|||
|
|||
![]() Quote:
TRANS + and - are for the dynamotor(s) HEATERS + and - are for the set heaters and relay supply SIGNAL is the buzzer line from the Driver Intercom box (Call Commander) SPEECH is the IC amplifier output for the Driver intercom The two unidentified wires will be HEATERS - and SPEECH, and can be traced with an ohmmeter fairly easily. The cable connects to the turret junction box (and then via the rotary base junction to the hull wiring for power and driver intercom connections. The reason for splitting the dynamotor and heater feeds is so that the set can be run from 12 or 24 volts by splitting the load across the 24 volt supply (if you have a 3-wire system) to equalise the battery drain. It's WS19 all right, and could be for anything from Matilda/Valentine all the way up to Sherman. A "multi-purpose part", basically. Chris. |
![]() |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
WS19 power supply unit needed | David DeWeese | The Wireless Forum | 4 | 26-11-17 13:37 |
C42 set power cable | chris vickery | The Wireless Forum | 5 | 03-07-16 21:34 |
Wanted: Mk1 Carrier Speedo cable center needed | Jim Burrill | For Sale Or Wanted | 12 | 15-05-16 08:56 |
Wanted: Power Plug and Cable for WS9/WS52 | Tim Bell | For Sale Or Wanted | 0 | 12-03-14 15:05 |
Sold: Cable for Power Supply | peter simundson | For Sale Or Wanted | 5 | 29-05-12 21:19 |