Cab 11 cowling seal

[Bob Carriere]

Hi Owen

You ca't always trust what you see on the web or on a multi owner 1940 vehicle.

Basically cab 11 where built BEFORE the rubber crisis/shortage so yes rubber was used on all joint surfaces....... best substitute now is thin foam neoprene rubber with one side with adhesive....... it compresses well.

Mac Auto and other Chev outlets like Chev of the 40's do sell both the rubber and the double roll canvas similar to jeeps BUT I do not think that it will compress enough. The canvass antisqueak was prevalent on some cab 12 and most cab 13 and Mac has a good selection again with one side sticky..... which is a great help when installing....... webbing is also used on the brackets of the fuel tanks, fenders and various body panels.

Cheers

[Owen Evans]

Aha, photo mystery solved!

Originally Posted by Bob Carriere

Hi Owen

You ca't always trust what you see on the web or on a multi owner 1940 vehicle.

Basically cab 11 where built BEFORE the rubber crisis/shortage so yes rubber was used on all joint surfaces....... best substitute now is thin foam neoprene rubber with one side with adhesive....... it compresses well.

Mac Auto and other Chev outlets like Chev of the 40's do sell both the rubber and the double roll canvas similar to jeeps BUT I do not think that it will compress enough. The canvass antisqueak was prevalent on some cab 12 and most cab 13 and Mac has a good selection again with one side sticky..... which is a great help when installing....... webbing is also used on the brackets of the fuel tanks, fenders and various body panels.

Cheers

All good points. Advancements in technology over the past 70-odd years have undoubtedly provided improvements over what was used back then.
But again, I can think of some "improvements" that should never have happened!

O.

[Dave Schindel]

The area I am talking about is at location A on the first pic. and the weatherstrip goes between the cab frame and the sheet metal.I will try to post a pic shortly.

[Bob Carriere]

Officially known as fender welts.... Flat rubber with one edge beaded...... so one and a half inch wide by 1/8 thick with a 1/4 inch bead on one side.

Available from most GM/Ford retro distributors.

My experience as been using a 1/8 foam neoprene about 1 inch wide easily found on EBay by the foot...... compresses and seals very well.

Bob C.

[Dave Schindel]

OK, thanks a lot guys.

[Dave Schindel]

I was looking around the web, and found all kinds of rubber sold in strips. Different thicknesses and widths. It's called "Rubber Sheet Warehouse". I ordered some 1/16 th x 3" and will cut it lengthwise down the middle.