Wireless Set No. 52 Canadian - Project

[David Dunlop]

While looking up this item in the Master Parts List for the 52-Set today. I discovered that the Wing Nut used to secure it was not listed at all. Which was interesting because two versions of this Wing Nut (3 in total) are used in the 52-Set in two separate locations.

The first photo shows the NUT, ANF, Steel, Wing 10-32 version used to secure the titled PADS in the 52-Set Receiver.

The second photo shows the NUT, ANF, Brass, Wing 10-32 version used on the input terminals of the COIL, Aerial Tuning No.2A. There is an identical terminal on either lower side of the Coil Case, the output transmission connector from the Sender can be attached to, depending on the orientation of the Coil on the 52-Set Carriers No. 4.

I wanted to post this information in case anyone was looking for it.

David