My CMP restoration

[Jon Bradshaw]

Are you saying this used to be your truck? or did you mean you also owned one like it?
Yes it has white paint underneath and was painted with grey after that at some time. The grey did not stick very well and is flaking off in a lot of spots.

[Gordons]

Yes I sold it running, it went to Onoway, alberta
nice to see someone rebuilding it

Originally Posted by Jon Bradshaw

Are you saying this used to be your truck? or did you mean you also owned one like it?
Yes it has white paint underneath and was painted with grey after that at some time. The grey did not stick very well and is flaking off in a lot of spots.

Attachment 105277 Attachment 105276

[Jon Bradshaw]

It is nice to see that you recognize it but do you know more about the history of it? Was it a truck from up there or did you buy it from someone who brought it north? Do you know what unit or base it came from? If a northern truck then it would be one of only a few possibilities....
I bought it as a running vehicle in pieces, made getting to the heart of the restoration very easy. Assembly might be more difficult since I didn't see it come apart. All good fun for the future.
I hope to have it green and ready to go by the time summer is here.
I will likely do it up in PPCLI markings from Europe since that is my regiment and Europe would have been the location of it's use. Although Italian campaign markings might be fun too.....

[Gordons]

I purchased the F15A from Ken Heiburg of Regina in 2005, and a 41 C15A from Mike Heiburg in Gronlid Saskatchewan in 2004, I believe they had been used on the farm, did you get the tool boxes.

[Jon Bradshaw]

I got the black tool box and the truck box but left them in Onoway until I have room for them. Since I am doing a water truck they are extra and not important to me right now.
Funny the truck has made quite a few trips since the end of it's "useful life".
It went from Regina to Yellowknife to Onoway AB and I am taking it to Picton ON this summer once it is done. I wonder where it will go after me?

[Gordons]

I'm sure the F15A will look great as a water truck, those tool boxes are very hard to find so hang on to them, the black one is off the early composite (CKD) Complete Knock Down, 2H1 body, built to save space for shipping

[Jon Bradshaw]

I have taken the transfer case off and will need to take it apart to replace all the oil seals on the drive shafts. They all seem to leak at least a bit and since it is off I might as well do them all. The darn thing is quite heavy to carry....
Does anyone have the seal numbers for these? I am sure one of you out there has cross referenced the old number with new ones?
I have also taken the filter to a local metal fab shop to see what they can do to make me a set of tops for the filter cans. The fuel tanks I got with the truck are not bad but for this one where I plan to try driving it on the road I am having them make stainless fuel tanks for it. These will last as long as I own it and never give me issues with corrosion. A bit pricier than doing the sealant swish in the tank but a lifetime fix, so worth it to me. I have more CMP's with rustier tanks so these fuel tanks won't go to waste.
For the filter pumps does anyone have the experience of stripping them? Mine seem to be very well stuck and will not pump at all. I see they are all brass except the pin holding the handle which is solidly stuck in.
I will take them apart and try to replace the leather seals but since they likely won't ever pump water it is a moot point.
The hose for the pump and tank is a very heavy rubber 3/4 inch ID and 1 1/4 inch OD I am looking into finding that now, so that I can have the 30ft on hand to do it up once I get to that point.
Still no luck finding good solid old brass taps for the back where the troops get the water out.