|
|
|
|
#1
20-02-19, 05:59
|
||||
|
||||
Seal sizes for transfer case
So I just pulled the seals out of my transfer case and they all appear to be the same size. One was so bad that the oil could have been drained out the gap instead of the drain hole.....
Two of them have a paper gasket behind the plate and they are in bad shape. The input one has a steel gasket in place and no paper ones. Any ideas on sourcing these paper gaskets? The steel one looks fine although I am unsure if it would work without a paper one as well? If it was aluminum or copper I could see it being a crush type but it is definitely steel (has rust). Thoughts on the gaskets? Should I just try to cut my own?
__________________
Many projects..... Complete- Ford F8 truck Complete-1956 Mk 2/3 Ferret Complete- Bofors 40mm on carriage Complete Reproduction- Vickers, Model 1937 Tank Waiting restoration- 1950 Cambridge carrier, Ford CMP Water truck, 1943 Universal carrier, 1945 Dodge APT truck, Canadian C3 Howitzer, several parts vehicles and a few ideas..... 
|
|
#2
20-02-19, 09:16
|
||||
|
||||
|
I believe the steel one to be a shim. In the MB-C2 manual there is a very good detailed write up on the servicing and rebuilding of the transfer cases.
__________________
Jordan Baker RHLI Museum, Otter LRC C15A-Wire3, 1944 Willys MB, 1942 10cwt Canadian trailer
|
|
#3
27-02-19, 16:04
|
||||
|
||||
|
Does anyone have a source for the through bolts used on these brass blocks and for the rear brake one? All of mine were rusted junk. Are the front ones the same as the rear ones?
__________________
Jordan Baker RHLI Museum, Otter LRC C15A-Wire3, 1944 Willys MB, 1942 10cwt Canadian trailer
|
|
#4
27-02-19, 22:29
|
|||
|
|||
|
Check these
|
|
#5
27-02-19, 23:21
|
|||
|
|||
|
NAPA has them complete with or without washers. You just need to know your thread size (usually 7/16-20 on most of the old North American stuff). Use the term "Banjo" bolt when talking to the (oldest) parts guy. I find the younger parts guys go crosseyed when you use common terms like this.
If you lived closer, I have a bin of about 50 of them out in the shed.
|
|
#6
28-02-19, 00:02
|
||||
|
||||
|
Ok great. I just wasn’t sure as there seemed to be different ones. I’ve got an old school NAPA in town. I’ll go visit them tomorrow.
__________________
Jordan Baker RHLI Museum, Otter LRC C15A-Wire3, 1944 Willys MB, 1942 10cwt Canadian trailer
|
|
#7
18-03-19, 06:13
|
||||
|
||||
|
Not truly a modern part but these are measurements from NOS felt seals used in the steering knuckles.
These are for the 6” ones but are the same for the 5” axles except in overall length. The length is 24-1/2”
__________________
Jordan Baker RHLI Museum, Otter LRC C15A-Wire3, 1944 Willys MB, 1942 10cwt Canadian trailer
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
