How To: C15a Wire-3 restoration

[Jordan Baker]

Hi Mike. Thanks for the info.

[Jordan Baker]

It was a busy afternoon in the shop today. The rear brake backing plates were primed then onto making a bunch of seals and installing a number of seals. Front tie rod got new outer dust seals. I made them out of neoprene. I used the dished washer to stamp out new ones in the press. The original internal felt seals were cleaned and re installed as they were in great shape. What a job getting the tie rod sealing plate installed. Thankfully the pulled could be used as a pusher to compress internal spring.

[Jordan Baker]

I also made up new neoprene seals for the steering control arm. Installed new front axle seals and the bearing races for the front steering knuckles. Lastly it’s fun trying to figure out where all the bolts go again.

[Bob Carriere]

We have been using the leather seals used on Dodge M 37.... the leather benefits form soaking in Neats Foot oil overnight but htye work amazingly well and readily available.


On the grease fittings or any other shinny bolt head...... get yourself a small bottle of gun blue solution available in blue or black.... they go black and seem to eventually hold paint better.


Bob C

[Jordan Baker]

Just re reading the manual section on the steering knuckles. Two questions come up for me.

#7 (yellow) mentions installing a new “retainer pin”. What is this pin retaining?

#2 (red) “pack the steering ball socket”. Just how much do I pack in there? Any pictures of how much?

[Phil Waterman]

Originally Posted by Jordan Baker

Just re reading the manual section on the steering knuckles. Two questions come up for me.

#7 (yellow) mentions installing a new “retainer pin”. What is this pin retaining?

#2 (red) “pack the steering ball socket”. Just how much do I pack in there? Any pictures of how much?

Hi Jordan

#7 The pin locates the center ball, without the pin the whole thing sort of falls apart as you try to put into the housing. Sort of like one of those Chinese wooden puzzles where you pull out one piece and it falls apart.

#8 how much grease- As much as you can get to stick to it, memory says there is a service bulletin that lists a weight of grease which I'll look for. The manual says to add grease, at service intervals, through the plug, but that to me is putting the new grease on the out side of the moving parts so I have a tube can insert through that plug into the center of the ball so that new grease gets pumped in to the center of the works.

Really enjoy watching your progess.

Cheers Phil

[Jordan Baker]

Hi Phil

I did not mean the pin that the centre ball sits on as referenced to in step 1. There is another pin that is driven in. It dissects the shaft below where the centre pin sits.