How To: C15a Wire-3 restoration

[Grant Bowker]

The Chevrolet inner shroud is a 2 part assembly. I was lucky enough to have several originals of the upper part but only a damaged original lower part. So, of course it became an exercise in figure out how to make a couple (if making one, I thought it better to make 2 so that I wouldn't have to re-learn how the next time I wanted one....).
Measure, draw, transfer from drawing to metal, cut, bend, beat the curved part added on the side, spot weld the reinforcement on the bottom and the extra part on the side, paint, install.