Aligning Centurion engine to gearbox

[Mike Cecil]

Malcolm,

Have you emailed John Blackwell at Pucka? They have been through the process installing the new engine in 005.

Mike

[Malcolm Towrie]

No, i haven't, Mike. I'll try that.
Malcolm

[Lauren Child]

I’ve not been on for a while, but we’ve done it at Duxford. Alas I was out on the day at a family do, but if you’re stuck I’ll ask the question. I’m fairly sure they used a magnetically attached feeler gauge in place of the big version in the book.

[Malcolm Towrie]

I think we have it figured out, Lauren. We're using the shaft from a old clutch installed between the engine and the gearbox. And using magnetic based dial indicators or maybe a laser alignment tool if I can borrow one to measure runouts at gearbox and engine ends.
The photo shows the shaft mounted to the gearbox. We don't have the engine in yet.

Malcolm

20190921_194553.jpg

[Lauren Child]

I asked the question today, and apparently we managed to borrow the special tool from a friend.

I guess that means we still have a 50/50 and ask the audience left for when the project restarts, but it looks like you’ve got it sorted anyway. I’d love to know how you get on

TTFN
Lauren

[Malcolm Towrie]

To close the loop here, I got the engine and gearbox aligned. Using the shaft from an old beaten-up clutch we had worked well. If you don't have an old shaft, seems to me you'd have to make something similar, which is quite a machining challenge.

I got really lucky. The runout readings taken with the dial indicator on the gearbox flange face and the crankcase face (see photos) indicated the engine was sitting about 1/4" low, relative to the gearbox. I made shims out of 3/16" plate and installed them under all four engine mounts. That brought the total indicated runout down from 0.060" to 0.020". Another 0.075" under each mount brought the TIR down to 0.008", which is within spec.

I was dreading this job, but it turned out to be simpler than I thought. I suspect that is due to the factory ensuring that the gearbox mounts and the engine mounts are parallel and that simply shimming up and down will correct misalignment.

I also suspect this spec is far too conservative for those of us running Centurions today. We're more likely to do 3 miles a year rather than 3000. So wearing out clutch, crankshaft, and gearbox components is pretty unlikely.

Malcolm

20191015_155531.jpg

20191016_162010.jpg

[David Herbert]

Well done Malcolm !
That is not a job that I would have looked forward to. Now you get to install the world's heaviest clutch !

David