Centurion Fuel Filter

[Malcolm Towrie]

John, it takes a lot of pumps of the priming lever on whichever fuel pump is pumping to fill both carbs. When the carbs are full enough to close the float needles, you should feel the priming lever stroke doing less work.

You can test the booster coil by unscrewing the booster coil connection from the right hand mag and holding the end about 1/4" from a ground while pressing the starter button. (The booster coil only works while the starter button is pressed.) You should see lots of sparking.
But based on my experience, the booster coil provides very little assist to starting. I bought a NOS one and it bench tested ok. But when I cranked the engine with just the booster coil providing the spark, it just fired occasionally and came no where near starting. As soon as I put the mags in service, she fired right up. I figure I wasted $400.

On our Mk 5/2, there's no shutoff on low coolant. There's no level switch on the header tank, nor on the wiring diagram, and the only thing that grounds the mags and stops sparking is switching the ignition switch to off, or pressing the mag test buttons.

Malcolm

[jdmcm]

Well got the old girl fired up today and she is running better than ever! The new fuel filter has made a difference for sure. Took many, many primer strokes to get the fuel pushed up in to the carbs...hundreds before any resistance could be felt, and I hit the old kigass pump about ten times and then got the first sputter from the engine in 3 weeks...so back at it with the priming, and some accelerator pedal action and she is alive...hopefully next week I will get a chance to try the lever flick shift test...just happy that she's back running...unlike a Sherman, moving a dead Centurion is not for the faint of heart or stingy wallet.

1st Parade....CHECK FUEL!!!!!!!

[eddy8men]

really pleased she fired up for you. i remember it took an age for us to bleed the fuel system back up again once we'd run it dry.
all the stuff you wanted is ready to go, just give me the word and i'll drop it off at carl's place.

[Malcolm Towrie]

John,
Congratulations on getting the old girl running!
Sounds like the fuel pump you were using to prime is a bit dodgy. If it gets worse, check out the fit/gap between the check valves and the pump housing. I removed the check valves and messed around lapping the disk 25 onto the seat 27 to no avail. I could only get about 2" Hg vacuum to pull fuel. Then I realized the valve could leak between the seat 27 and the fuel pump body since there is no gasket. I'm used to seeing a gasket here on other vehicles. Using some Aviation Gasket goop to glue the seat to the body increased the suck to 5" Hg, a big improvement. Hope it lasts.

Malcolm

SnipImage-%7B3504124F-4B0C-45E0-8AAB-DACA89BB2E21%7D[3].jpg

[jdmcm]

Hi Malcolm, Rick

yes sir, I think we could benefit from a pair of new pumps or a rebuild, I remember on my FV432 that the fuel crossover/drain also had only one gasket where I felt it needed two...

Rick I will PM you on the parts, thank you

I am going to get the old girl in the shop at the end of the month for some interior work so pumps over the winter I think

John