Hetzer preselect gearbox compared to Ferret

[James P]

Have you contacted other 38(t) owners like Saumar, Bovington, Sinshiem, Munster or Bruce Crompton for assistance in how to operate the vehicle ?? You start beating the bushes and do some outreach via the net and no doubt you will connect with folks who can provide advice galore and printed material.

[Malcolm Towrie]

James, I don't look after the Hetzer, I just got called to do a repair on it after it arrived and I was interested in the drivetrain. I believe the owner is awaiting some spares from Poland where it was purchased, and I have suggested that he gets copies of whatever manuals they have. I assume they have manuals since they completely restored it.

Malcolm

[maple_leaf_eh]

Malcolm

I saw the reveal and heard the nearly 45 minute presentation. Very interesting. Now that I realize the history, I think a quick call to the Swiss Embassy in Ottawa asking for an introduction to the Swiss military's historical section or their armour museum might be faster. Swiss are a polite people, and they like to know who they are dealing with.

[Tobias Weibel]

Good day to all of you.

I work in the workshop of the Swiss Military Museum Full-Reuenthal. We are one of the largest military museums in Switzerland.
We have two G13 (petrol and diesel engine)

I can organize or scan a G13 manual.

Tobias

[James P]

Great to see another MLU member (Tobias) stepping up and offering assistance. Seriously if you are plonking down a load of cash for a vehicle you should buy all the manuals possible, it is really not all that difficult. Case in point............

https://www.ebay.com/itm/WW2-German-...-/391441687153

[Malcolm Towrie]

Originally Posted by Tobias Weibel

Good day to all of you.

I work in the workshop of the Swiss Military Museum Full-Reuenthal. We are one of the largest military museums in Switzerland.
We have two G13 (petrol and diesel engine)

I can organize or scan a G13 manual.

Tobias

Tobias, that would be very useful to us! We have no documentation to go with this very nice Hetzer we have just acquired. This is a Praga petrol-engined version.
Malcolm

[Tobias Weibel]

Here is a preview







The rest is in the works

[David Herbert]

Ok,
From the above it can be seen that each side functions separately. Slowing one side does not speed up the other so there is no regeneration unlike a controlled differential (Sherman / Stuart) or Merit Brown (Centurion / Cromwell etc).

The two outer bands are simply brakes to stop that track.
Each side has a clutch which is spring engaged like a car clutch. If engaged with no brakes applied that track is in high gear (normal for straight running).

Clutch disengaged with no brakes gives neutral which if the other side is still in high, will result in a gentle turn towards the side in neutral depending on road conditions. However on a down slope the vehicle will turn the other way which can be exciting.

Clutch disengaged and the inner brake band applied will give low gear to that track resulting in a geared turn (if the other track is in high) of a radius depending on the gear ratios.

It is possible to design the controls so that it is possible to have one track in neutral with the brake applied and the other in low, resulting in a pivot turn with one track locked but it seems from Malcolm's earlier post that that has not been done here. On Crusader it was relatively easy as the brake bands were air operated so all that was needed was a rather ingenious valve block.

The Praga-Wilson main transmission I think is a five forward one reverse unit, very similar to those used in cars and buses in the UK.

I do not know what the units are on the front of the engine.

David