Info needed: Chevrolet Cab 12 wiring

[Jordan Baker]

I believe vinwire in Australia makes a harness for the 11/12 cab trucks. They made my harness for me and I was very happy with it.

[Owen Evans]

Originally Posted by Jordan Baker

I believe vinwire in Australia makes a harness for the 11/12 cab trucks. They made my harness for me and I was very happy with it.

Indeed they do, and I too was rather happy with the product. A few reference photos in post 11 here:

http://www.mapleleafup.net/forums/sh...hlight=harness

They told me their Chevrolet cab 11/12 harness pattern came off a Cab 12 FAT, btw.

Owen.

[Phil Waterman]

Hi Zdenek


Hope these photos will help with the routing of the wiring harness under the hood. What is shown is my C60L Pattern 12 with a new wiring harness, it was installed based on the existing original harness that was pretty much intact.

Pat 12 Wiring Harness 002 copy.jpg

Pat 12 Wiring Harness 003.jpg Pat 12 Wiring Harness 004.jpg Pat 12 Wiring Harness 005.jpg

The wire attachment blocks shown are from a Jeep parts source and are a match for the originals.


Cheers Phil

[Zdenek Svestka]

Hello everybody,
thanks a lot for your answers, it helped me to go on with the restoration.
So far I managed to connect recharging and ignition...

Originally Posted by Phil Waterman

The wire attachment blocks shown are from a Jeep parts source and are a match for the originals.

The blocks are from Jeep? But which type? What I know it has more attachments... Or did you modify it?

Zdenek

[Bob Carriere]

The blocks shown by Phil is a generic and is sold by quite a few restoration retailers, Chevs of the 40s, Jim Carter,etc......

For the cab 11/12 the 3 connection ones are what I have seen as originals.....you can use one of the mounting end screws for a ground.

Good luck