Mortar stowage part or?

[haerikj]

Good suggestion. I will grit blast it and check for any number

Best
Hans Erik

[haerikj]

The number is:

[Michael R.]

This should resolve your question. TL14086R

[charlie fitton]

I need to make one of them...care to post dimensions?

[haerikj]

Thanks
What is this part? I have 3 screws for fasten some wodden part inside, and no hole at the rear end as in your picture.
I will measure the dimensions in a few days.

[Michael R.]

That truncated cone shape device is the rubber housing over the lamp socket for your rear facing light. The metal bracket you have been asking about creates a housing to mount and protect the lamp and switch assembly.

Your MK-II mortar carrier uses Single Pole wiring. That wiring diagram was previously posted to you on your FB page identification request.

A similar original assembly is available from Stefan in NL at LWDparts.com