Carrier seats

Ron Pier · #1 21-03-20, 21:46

Well I couldn't wait till the morning. I've just checked my gunners seat back with a metric vernier that was close by and it's about 9.5mm. Ron

stephen crowhurst · #2 21-03-20, 23:39

Thanks Ron, so that is 1/2" for the drivers seat and 3/8" for the gunner seat.

Cheers Stephen

Ron Pier · #3 22-03-20, 00:04

Correct. I guess more strength in the drivers seat as it's longer and not flat on the bulkhead. Ron

Larry Mass · #4 22-03-20, 05:23

Thank you very much to all that replied it was a great help, its awesome to see the fellowship on this site
Thanks again Cheers
Larry

Lynn Eades · #5 22-03-20, 09:14

I have an original radiator cover. It is three ply. The center layer is thicker than the two outers is that what your 9.5mm ply is Ron?

Ron Pier · #6 22-03-20, 17:06

Here's mine Lynn. 3/8" x 3 ply. Ron

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode