|
|
#11
08-05-20, 03:22
|
||||
|
||||
Today was spent working on the antenna mounts for the roof. So far one is pretty much done except for some minor welding. I stopped as I ran out of gas for the welder. The plates were copied from an original British FFW plate I had picked up years ago. The ends were pressed braked to get the radius bends to fit over the roof structure.
To make these bends in the 1/8” plate I had to make up a small press brake jig to use in the shop press. I’m quite impressed with what it can bend.
__________________
Jordan Baker RHLI Museum, Otter LRC C15A-Wire3, 1944 Willys MB, 1942 10cwt Canadian trailer 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 1944 C-15A-Wire-5 Restoration | RichCam | The Restoration Forum | 706 | 18-05-23 02:43 |
| Sold: 1944 Chev C15A Wire-3 | Don Dingwall | For Sale Or Wanted | 11 | 02-04-15 23:26 |
| What was once 2, is now 1. (C15A-Wire-5) | RichCam | The Softskin Forum | 3 | 30-12-11 22:49 |
| photos needed for c15a wire 3 van body | jason meade | The Softskin Forum | 5 | 10-08-11 06:29 |
| Wire loom for C15A Cab13 | Jordan Baker | The Restoration Forum | 19 | 28-08-06 03:42 |
Threaded Mode