M38A1CDN2 Antenna Mast assy

[Retsarge]

Rob,
Thanks for the information on the antenna mast assy. I found both the base and reinforcing ring listed on ebay..ouch...l think that l will look around for more reasonable prices than there. But at least l know the correct parts that l need for my jeep. If the 2021 MVPA convention in south bend, indiana takes place, in sure that l can find one there. Thanks

[Eric B]

Hello, the radio set up in the m38a1 CDN is uniquely Canadian as are the brackets. The only items shared with the U.S. m38a1 is the actual radio equipment. I posted the instruction here previously.
You will have to decide if you want a1or 2 radio set up as that will determine what CDN brackets you will need.
Generally the spare tire radio antenna mount was used for a single radio antenna, but they were also mounted on the left rear corner.

None of these brackets would be commonly available in the USA unless imported.

Not all vehicles were set-up for a radio.

As Rob indicated he and Frank have some brackets. Unless Rob has any spare tire extensions left it might be easier to get the brackets needed for the left rear corner mount.
The radio tray also was attached to a uniquely CDN bracket.

Thanks Eric

[rob love]

I think I have several of the Cdn tray adapter brackets to spare, and I know I have the antenna bracket that goes on top of the spare tire mount. However, I recommend against those spare tire mounts, as they cause a lot of stress and cracking on the back wall of the jeep body. The corner mounts are a much better idea.