|
|
|
|
#1
07-01-21, 17:02
|
|||
|
|||
Hi Lynn,
Thanks for the info on the engine cover screws. I'll have a look for some 3/8" BSF thumb screws. If I can't find any standard bolts will have to do for now. Re the exhaust, what do you mean by sub-calibre? I've used 38mm pipe throughout, is that too small? Cheers, Tom
__________________
By Skill and by Fighting 
|
|
#2
07-01-21, 17:19
|
|||
|
|||
|
If it fits the various cast elbows on the exhaust system it shouldn't be
|
|
#3
07-01-21, 18:50
|
|||
|
|||
|
I've used 38mm from the cast elbows in the floor, through the whole system. The picture does make it look smaller than that though.
__________________
By Skill and by Fighting
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Lower Engine Cowling | Adrian Mamzer | The Carrier Forum | 7 | 30-09-16 06:17 |
| Engine top cover LP2 | Lew Skelton | The Carrier Forum | 1 | 16-07-12 14:55 |
| Thumbnuts. TL3596, for lower engine covers | Lynn Eades | The Carrier Forum | 6 | 19-04-11 19:26 |
| lower Mk1 engine covers. | kevin powles | The Carrier Forum | 0 | 07-05-10 07:33 |
| Lower engine covers | Jordan Baker | The Carrier Forum | 2 | 13-12-05 20:01 |
Hybrid Mode
