|
|
#4
29-05-21, 00:59
|
|||
|
|||
Aha! Phil, that will explain the 90 degrees. I was only thinking of the hole down the side of the bell housing, not one on top.
Malcolm is there a ball bearing pressed into the front of the flywheel, which should time through the lower hole? That's how a British GM was timed.
__________________
Bluebell Carrier Armoured O.P. No1 Mk3 W. T84991 Carrier Bren No2.Mk.I. NewZealand Railways. NZR.6. Dodge WC55. 37mm Gun Motor Carriage M6 Jeep Mb #135668 So many questions.... 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Ferret Fluid Flywheel rebuild | Robin Craig | The Restoration Forum | 23 | 03-10-17 01:18 |
| Points vs Electronic ignition and Pulley timing mark | Mark Towers | The Restoration Forum | 9 | 31-05-17 22:20 |
| Wanted: WLA flywheel | Harlé Sylvain | For Sale Or Wanted | 2 | 28-11-16 21:57 |
| Inert British WWI Mark VI and WWII Mark VI Display Ammo | horsa | For Sale Or Wanted | 1 | 24-10-06 18:44 |
| Something is wrong here | Bill Murray | The Sergeants' Mess | 10 | 10-02-05 15:39 |
Threaded Mode