WS 19 in a Mk2 carrier

[Chris Suslowicz]

Originally Posted by Petr Brezina

Hi Chris,
yes thats correct, AOP doesnt have folding seats so this supporting bracket is a must here. On UC wireless set carrier is supposed to lay on the lowered folding seat.
What surprised me is that mounting bar on the drawing is definitely not the same as on my carrier and also shape of the WS carrier looks odd. I would say its not No.21/22/23/25 - any of these. Perhaps again something special? What do you think?

I think the drawing is only supposed to refer to the support bracket (the set carrier is a "this is a quick sketch of what goes on top but I don't have the details and you don't need them yet" - indicated by the broken ". _ . _ ." line used for that part of the drawing).

I suspect it's a permanently-fitted Carrier No.21 as the AOP Carrier is a single purpose vehicle and there's no reason to have the set removable for use as a ground station.

Best regards,
Chris. (Still not convinced about the single mounting bolt and "rest it on the seat pan" idea for your carrier. It seems a bit insecure to me - especially for cross-country use.)

[Petr Brezina]

Thanks Chris, thats very useful discussion.
You can be right about the sketch, true is that we still dont have any drawing with the carrier and WS mounted in the UC.
Regarding the folding seat - there is a welded plate coming from the engine cover which supports seat in down position, you can even bolt seat to it (mine is missing hole in it, but should be there - now I believe to know why is this that hole there for - no such hole on the gunners side). So I believe that it could be very rigid and sturdy support.
Im obviously missing something WS carrier is locked in on the outer edge of the seat.

[stephen crowhurst]

This is the way my rear seat is set up for the mounting of the radio. There is a Dzus fixing in the corner. Hope this helps.

[Petr Brezina]

Lovely, thank you very much Stephen for these details!

[Petr Brezina]

Just finished shock absorbers underneath the carrier. I made them from a similar shape shock absorbers which were available over here. They are about 8mm higher than originals but I can live with it I guess.

[Robert Bergeron]

Nicely done Petr.

[Petr Brezina]

OK, so after a while Im back with my WS19 project. Chris, have you had a chance to make couple of pics of your No.25 carrier, please? It would help me a lot because there is still a lot of unclear things to me. Many thanks in advance!