Carrier Soft Parts

[Lynn Eades]

Reviving an old thread. Here are a couple of original fuel lines for the interest of the purist nut jobs.
With one of them being 1/40 dated, these will be British origin.

[Lynn Eades]

Well no matter what I do, they come through top side down.
Here are a couple of the radiator mount. The rubber block is nominally 1 inch wide and tapers from the front 47mm high to 40mm high at the back. The hole through the middle accepts the 3/8" dia bolt.
I believe (from Michael R) that there was a mod to hold the bolts at the bottom.

[Lynn Eades]

Hopefully someone can flip my pictures.
Next for this visit is the fibre coupling (drive) for the generator. (shown with the armature dog)

[Lynn Eades]

And another of the fuel cap seal to better show it was leather.

[marcel both]

Thanks for sharing the information included the rubber blocks for the radiatormount.
This will helps me to make new rubber blocks for my carrier.

[Lynn Eades]

Marcel, I had some cut with a water cutter. Worked out good.