How do I cut 1/2" rubber mats?

[rob love]

Best thing I have found for cutting rubber is a straight edge and razor knife. That is assuming it does not have the little pieces of steel belting in them. Cut once, bend it a bit, cut again, and repeat until it is done. And of course, use a brand new razor blade.
Anything like a saw or grinder disc is going to make an incredible amount of dust or clog up as the heat turns the rubber to goo. Perhaps running water on the cut like you would with cement might help.

[Mike Cecil]

I recently had to cut some 6.00-16 tyres from wheel rims. I used a Sawzall with a demolition-toothed blade to cut out a big 'U' in the rubber down to the steel wires/belt, then an angle grinder with a metal cutting blade to nip through the steel part once I prised it just clear of the wheel rim using two large screwdrivers. Worked well: some mess of rubber granules from the saw, and a little acrid smoke from the grinder, otherwise no problem at all.

Unless you want a clean edge, the Sawzall worked well.

I've used a non-slip tape on steps and it works really well.

Like this: https://www.amazon.com/Slip-Guard-No.../dp/B01HQXNBHW

Mike

[maple_leaf_eh]

I have cut scrap tires with a reciprocating saw and a grinder, and was unimpressed by the results.

I may use two straight edges clamped down, and just get going with handsaws and knives. Whatever works.

[r.morrison]

Number 1: I agree with Rob. You'll go through a few blades cuz he's right about the new blades. Number 2: The smart guy would go to PRINCESS AUTO..."man's answer to every problem in life" and buy the Non Slip Tread that they sell in a roll and you can cut to any length. And it goes on sale once in a while. You can probably order it on line.
My 2 cents.....Robert

[Jesse Browning]

Rubber, unless it has the formed surface like a tire is extremely slippery. Even rough rubber will be slippery if its in the shade and moss grows on it. The house I moved to had shredded rubber mats. They were slick as banana peels.

[REL]

It's surprising what a water-jet machine can cut, and very precisely too. Some even do bevels.

[Matthew P]

I've done tires (7.50x20 for a trailer next time I'll just outsource the removal to the tire shop, paint the rims and come back...) and stall mats for horses. Those are circa 3/4" thick. You're two options, and each work in their own way is the utility knife or a reciprocating saw. The utility knife seems daunting at first and you think it'll take forever, but you'll be surprised how fast you can cut the rubber. The other way is to use a sawsall, jig-saw or similar at slow speed. As mentioned previously heat is your enemy here.

Matt