SUPPLY UNITS, Vibratory, No. 52 ZA/CAN 4354
A couple of relatively straight forward little jobs today which pretty much finish the work needed to be done on the Vibratory Supply assembly.
The first was to clean up the surface rust that had accumulated on part of the bottom of the case for the Vibratory Supply in the back half of it.
A pair of scrubbings with the brass ‘toothbrush’ and my favourite cleaner was followed by a water rinse. I then used a small cotton BBQ sauce mop, soaked in a 50/50 solution of CLR and cold water, to scrub the rusty surface for about 2 minutes and then rinsed the case in cold running water for another two minutes. This was followed with hand drying the case and then placing it in the oven at 150 degrees F for half an hour to make certain all water had dried off completely.
Once that was done, it was on to the last repair for the case.
David
|
31-01-22, 02:27
Similar Threads
Threaded Mode