|
|
|
|
#1
10-02-22, 20:22
|
|||
|
|||
After doing more searching it looks like all the suppliers I found are selling the same seal. Having the pump off for the 3rd time I am coming to the same conclusion as the above posters( thanks guys! ) that the pump body needs refinishing where the seal mates to the casting. I have a milling machine so this should not be a problem. If the casting is the problem, then the seal kit I am using is likely fine. Thanks for all the advise.
|
|
#2
10-02-22, 20:36
|
|||
|
|||
|
Mike, I looked up the post you made in the carrier forum, good one .
|
|
#3
17-02-22, 05:22
|
|||
|
|||
|
In the end I re-surfaced the casting where the seal contacts the pump and no more leaks from that area. The new pump gaskets were made of very poor quality paper and had to be replaced. all is well now. Thanks for all the help.
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| The elusive F15A FRONT Grease seal | sth65pac | The Restoration Forum | 12 | 21-11-19 11:35 |
| water pump | stephen crowhurst | The Carrier Forum | 2 | 03-05-12 00:32 |
| Water pump question | SDeMocko | The Carrier Forum | 2 | 06-01-11 05:15 |
| Water pump | peter simundson | Post-war Military Vehicles | 1 | 19-08-09 17:47 |
| Water Pump | Neil Ashley | The Carrier Forum | 2 | 06-05-09 00:10 |
Hybrid Mode
