Info needed: C15A 2B1 cargo bed rebuild

[Paul Edwards]

Thank gents very helpful.

Does anyone have pattern/measurements for the metal rear mud flaps?

Apparently the footman loops are very similar to those on the GP found on Joe's Motor Pool here in the UK

Cheers,


Paul

[Paul Edwards]

Today's progress, hinges

Footman loops on order from Joe's Motor Pool UK, these are meant for GP Jeeps but very similar.

Any mud flap information welcome.

Next will be hood bows

[Hanno Spoelstra]

If you’re making hood bows make sure to use a wide enough radius. It should measure 10 inches IIRC. I’ll check my measurements when I’m back home.

Just mentioning this as I often see repro hood bows with a radius which is too small.

[Paul Edwards]

Thanks Hanno, I appreciate that, I want it to be correct and only pay out once.

Cheers,


Paul

[Bob Carriere]

Hi Paul

Your early 2B1 was made before the "rubber" restrictions.......so your flaps should be plain 1/4 in. thick rubber bolted to the rear flat mud defector of your truck.

PS...... on your truck box...underneath.....the rear floor support bracket closest the rear wheel has a 45 degree inclination...... a flat piece of steel.....fairly stiff is bolted flat to that cross member....bolt holes should be visible....... in turn the rubber mud flap is bolted to the bottom edge of the deflector......

[Grant Bowker]

The mounting holes on the structure of the 2B1 box Bob refers to for mud deflectors are highlighted in the modified version of your photo attached.

[Paul Edwards]

Thanks guys..............early ehhhhh.

So the mud flap is simply sandwiched between the 45 degree cross member and a steel plate? Am I understanding this correct?

Don't suppose any images of the rubber flaps exist, should I just take an educated guess at the length of the flap?

Cheers,


Paul

[Hanno Spoelstra]

Originally Posted by Hanno Spoelstra

If you’re making hood bows make sure to use a wide enough radius. It should measure 10 inches IIRC. I’ll check my measurements when I’m back home.

Just mentioning this as I often see repro hood bows with a radius which is too small.

See the thread Top Bows - 15-cwt truck for photos and dimensions. AFAIK the dimensions for the 2B1 box are the same as for the 2C1.