|
|
#31
09-10-22, 20:44
|
|||
|
|||
BOXES, Tool, No. 1 WS Cdn. 52. ZA/CAN 4727
This morning, I was able to measure up and trim the stencil for the Tool Box markings to fit properly on the front of the box, when the time arrives to do the stencil.
Once I figure out how to hold it in place while doing the stencil, I should be good to go. My options at the moment are tape, rubber cement, or some combination of the two. David 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Canadian staff car wireless: World War 2 Canadian R103 Receiver Demo | Mike K | The Wireless Forum | 5 | 24-07-16 16:20 |
| Found: CMP Wireless body project | Jim Burrill | For Sale Or Wanted | 7 | 05-04-15 01:02 |
| Canadian dehavilland mosquito restoration project | David Dunlop | WW2 Military History & Equipment | 9 | 10-07-14 01:51 |
| Canadian project | David Ellery | The Carrier Forum | 9 | 28-04-07 02:36 |
| FOR SALE/TRADE: 1944 CHOREHORSE PROJECT for Signal Corps Wireless Power Unit Project | Alain | For Sale Or Wanted | 1 | 21-02-07 01:11 |
Threaded Mode