|
|
#14
31-10-22, 00:02
|
|||
|
|||
hooks
next up was to fabricate the hooks. I used the torch to heat up some 5/8 hot rolled rod and flattened out the ends, then I trimmed them to shape and ground the edges. Then heated them up againand did the u bends. Next was to bend the loop into a link of the chain, I neglected to take a good picture but it shows the before and after in the one picture. Then hung the chain and cut to proper length.
Which i use to hold the tailgate flat, the originals are a few inches longer. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Fabrication thoughts. | Scott Cacciamani | The Restoration Forum | 8 | 08-10-22 16:46 |
| How To: Fabrication of Wooden 2H1 Body | RichCam | The Restoration Forum | 7 | 20-03-15 02:38 |
| Rear deck fabrication | Dave Schindel | The Carrier Forum | 2 | 18-03-12 21:53 |
| More T16 Parts Fabrication | horsa | The Carrier Forum | 8 | 06-06-07 04:02 |
| T16 Parts Fabrication | horsa | The Carrier Forum | 8 | 14-09-06 17:49 |
Threaded Mode