![]() |
|
|
|
#1
|
||||
|
||||
|
Thank you very much Phil , that is a great idea ! In my case the roof is made of two aluminium sheets . The challenge is to prevent water from seeping in by the dozens of holes created by sheet metal screws , bolts and lag screws .
__________________
44 GPW / 44 C-15-A Cab 13 Wireless 5 with 2K1 box X 2 / 44 U.C. No-2 MKII* / 10 Cwt Cdn Brantford Coach & Body trailer / 94 LSVW / 84 Iltis |
|
#2
|
||||
|
||||
|
There are 14 hooks total , 7 each side attached to the aluminium roof . They serve as anchors to hold up the penthouse tent . Logicaly that tent goes on the left ( passenger ) side where the map table hooks up on the outside wall . Why they would have hooks on the generator compartment side is beyound me , mere restorer .
__________________
44 GPW / 44 C-15-A Cab 13 Wireless 5 with 2K1 box X 2 / 44 U.C. No-2 MKII* / 10 Cwt Cdn Brantford Coach & Body trailer / 94 LSVW / 84 Iltis |
|
#3
|
||||
|
||||
|
Hooks on the cypher clerk side of the box . A lot of hooks . Originaly they were set with flimsy rivets and all of mine were gone. I went with 1/4” bolts after enlarging slightly the original holes along the roof .I will be using an awning instead of a tent .
__________________
44 GPW / 44 C-15-A Cab 13 Wireless 5 with 2K1 box X 2 / 44 U.C. No-2 MKII* / 10 Cwt Cdn Brantford Coach & Body trailer / 94 LSVW / 84 Iltis |
|
#4
|
||||
|
||||
|
Primed the underside of the new floor today . Nice & tidy .
__________________
44 GPW / 44 C-15-A Cab 13 Wireless 5 with 2K1 box X 2 / 44 U.C. No-2 MKII* / 10 Cwt Cdn Brantford Coach & Body trailer / 94 LSVW / 84 Iltis |
|
#5
|
||||
|
||||
|
Reunited at last .Now that the box has a good roof and good floor it was time to reunite it with the truck . It will be easier to move it in and out of the garage and take less room than when they were seperated .
__________________
44 GPW / 44 C-15-A Cab 13 Wireless 5 with 2K1 box X 2 / 44 U.C. No-2 MKII* / 10 Cwt Cdn Brantford Coach & Body trailer / 94 LSVW / 84 Iltis |
|
#6
|
||||
|
||||
|
Need a spare tire to fill that big hole on the side . Next a ladder to climb on the roof , Jerrican holders and tools & chain lockers for the underside . That will be it for this summer , i am flying across Canada again in August . Will try to see my MLU friends along the way . At least those living near an airport . Next winter i will do the interior finishing of the box .Meanwhile i will be checking for more original parts for this restoration . Give me a heads up if you find / have anything you are willing to sell / trade . Cheers for now .
__________________
44 GPW / 44 C-15-A Cab 13 Wireless 5 with 2K1 box X 2 / 44 U.C. No-2 MKII* / 10 Cwt Cdn Brantford Coach & Body trailer / 94 LSVW / 84 Iltis |
|
#7
|
||||
|
||||
|
Fitted nicely the driver compartment doors , anchored the box tightly to the truck frame and built a roof ladder today.
__________________
44 GPW / 44 C-15-A Cab 13 Wireless 5 with 2K1 box X 2 / 44 U.C. No-2 MKII* / 10 Cwt Cdn Brantford Coach & Body trailer / 94 LSVW / 84 Iltis |
![]() |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Wire Reel | James D Teel II | The Wireless Forum | 7 | 26-07-20 04:57 |
| wire 5 box | jason meade | The Softskin Forum | 12 | 21-06-14 01:59 |
| FOR SALE/TRADE: 1944 CHOREHORSE PROJECT for Signal Corps Wireless Power Unit Project | Alain | For Sale Or Wanted | 1 | 21-02-07 01:11 |