|
|
|
|
#1
09-09-25, 19:06
|
|||
|
|||
COIL, Aerial Tuning No. 2 A ZA/CAN 4725
The two stencils have now been cut for the luminous paint pads to be applied to the front panel of the Coil, Aerial Tuning No. 2A. I am using plastic stencil sheeting for this part of the work. This will allow me to easily see the front panel to correctly place the stencils.
The next step will be to cut this sheet in half and trim the two stencils to fit above and below the reinforcing plate spot welded to the front panel to help stabilized the tuning dial assembly. For reference, the photos in Post 1171 illustrate where the two decals must go and the problem of needing to work around the reinforcing plate. David 
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Canadian staff car wireless: World War 2 Canadian R103 Receiver Demo | Mike K | The Wireless Forum | 5 | 24-07-16 15:20 |
| Found: CMP Wireless body project | Jim Burrill | For Sale Or Wanted | 7 | 05-04-15 00:02 |
| Canadian dehavilland mosquito restoration project | David Dunlop | WW2 Military History & Equipment | 9 | 10-07-14 00:51 |
| Canadian project | David Ellery | The Carrier Forum | 9 | 28-04-07 01:36 |
| FOR SALE/TRADE: 1944 CHOREHORSE PROJECT for Signal Corps Wireless Power Unit Project | Alain | For Sale Or Wanted | 1 | 21-02-07 00:11 |
Hybrid Mode
