![]() |
|
#1
|
|||
|
|||
![]()
The solution to this problem is pretty straight forward and not as expensive as you might think. Don't know the sources down your way but here is a Canadian/US company that I've had good luck with. http://www.motionindustries.com/moti.../mi/motion.jsp
So far I've used Speedy Sleeves in the following CMP applications, engine front and rear seal on the crank , transmission tail shaft, transfer case all of the input and out put shafts. And they do have sleeves large enough for the front hubs.
__________________
Phil Waterman `41 C60L Pattern 12 `42 C60S Radio Pattern 13 `45 HUP http://canadianmilitarypattern.com/ New e-mail Philip@canadianmilitarypattern.com |
![]() |
Thread Tools | |
Display Modes | |
|
|