|
|
|
|
#1
10-04-07, 04:27
|
|||
|
|||
Here is the trick.....
The sliding gear must fit on the splined shaft in such a fashion that will allow it to mesh with the inner gear of the large bottom gear.......
If you look carefully at the inside of the bottom gear you can see the inner cut teeth........ when I installed mine I didn't know the spline had only one way to fit......
__________________
Bob Carriere....B.T.B C15a Cab 11 Hammond, Ontario Canada 
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 2016 at the Hammond Barn | RHClarke | The Restoration Forum | 83 | 08-01-17 19:22 |
| 2014 at the Hammond Barn | RHClarke | The Restoration Forum | 63 | 01-01-15 22:50 |
| 2013 at the Hammond Barn | RHClarke | The Restoration Forum | 85 | 06-01-14 00:29 |
| 2012 at the Hammond Barn | RHClarke | The Restoration Forum | 149 | 01-01-13 02:27 |
| Hammond Barn Visit | Wpns 421 | The Softskin Forum | 1 | 15-12-09 04:17 |
Hybrid Mode
