2008 at the Hammond Barn

[Bob Carriere]

It is very interesting and frustrating to see the different size of the dots & dashes from two different plates...... I suppose different dies. different lots and different wear on the dies...... the donor plate had bigger dots and dashes and made lining them up difficult.

Grant being a perfectionist took the time to grind/carve the little boats back after we had the welding done...... he finihsed with a Dremel tool and fine stone to remove the grinding marks..... after some paint ti will almost be invisible.

The other problem we encountered is that the floor was seriously distorted from the back side being pressed in by the huge punches that created all the variuos openings in the floor...... if you put a straight edge on the under side there are marked depressions around the fuel valve hole... the battery cable hole and the shift lever hole we were patching...... but Grant persisted in getting a smooth finish.