MET Gas

[Justin Pollard]

Hello all,thats a top looking job your doing there Ron.thanks for sharing.

[ron]

Hi Guys,
I am on the scrounge, I need a sleeve to fit into the diff mounting bracket its One and half inches wide by three eigths thick the part number is 708/8, if you have a pair and dont wish to split them then I will buy the pair of course, I hope there is someone out there that can help,
Thanks in advance, Regards, Ron

[ron]

Hi Justin
Thanks for the kind comments, when you get your carrier if I can be of any help just ask,
Thes two pics show the diff mounting that had been cut out by the previous owner refitted,
Regards, Ron

[Justin Pollard]

Thanks Ron,no doubt i,ll take you up on that offer somewhere along the line.
Justin.

[ron]

Me again more scrounging,
Does any one have for sale a pair of driven arms that conect the gear box to the duplex coupling and the coupling to the diff,
Thanks in advance,
Regards, Ron

[ron]

Here is a pic of the arms that I require to enable me to fit the engine and gear box to my latest carrier, If you have a pair of these that you have no need for please let me know,
Thanks in advance, Regards, Ron

[Tony Smith]

Is the gearbox flange the same piece as the splined pinion flange for the 2A? I see your parts diagram shows the tapered keyway version for the LP2, and splined version for the LP2A.

[ron]

Hello Tony.
And thanks for your reply, The part that fits on to the gear box is spined. but I need a part with a key way to conect to the diff. this Met gas carrier is a 2,
Regards, Ron