truck heaters rear body C30 WIRE

[Vic Eaton]

HI THERE ROLF
Good to here from you you will light it if you get cold enough
yes so fat im pleased with what i have managed to create the worst bit is to come i fear getting the metal around the frame to cover it all inand trap the heat from the chimmny then comes the mounting on the truck the holes are all there . the top of the heater is a stainless steel dish i got from the school kitchen when no one was looking the burner sits on the bottom of a fire bucketi cut down the funnel is from my tractor to take the fumes away the tubing is from an old water heater and has a spiral inside it to direct heat to the chimmny sides for the second fan the copper tubes are just 15mm standard water pipe so its all a mismatch of bits and pieces that were free . even the springs i got from an old washing machine the top and bottom half inch thick steel plates were the ends of dumbells found in the school . i altered a little
vic uk .