#1
|
|||
|
|||
Canadian Dodge APT with Dual PTO
Hello everybody,
I’m overhauling the PTO (and some more things) of my APT. Putting it together I discovered a problem: Usually the PTO of the Canadian Dodge and the US-Dodge are the same. But it looks as if I have a different (may be younger) one. Because at the rear I have an end plate with a hole for the drive shaft (dual PTO) and an oil seal with a different outer diameter to that one at the front end (watch the picture with the parts - you can see that). Of course a bought a PTO gasket and seal set. Following the explanation of “Dodge Vintage Power Wagon” it’s a set for the 1 Ton Flat Fender Power Wagon 4x4 Civilian & Export. But the two oil seals for the drive shaft are similar, so I can’t use one of them for my end plate. I'm looking for that smaller oil seal. And I made a measurement: The inner diameter of the seal (and also of course the diameter of the mainshaft) is 25mm (like at the front end) and the outer diameter is 39,6mm (1,56") Does anybody knows that problem or knows which PTO it is? Thanks in advance for your support. Attached pictures: 01 PTO still installed 02 PTO clos up 03 end plate with hole for the drive shaft 04 comparison 05 oil seal outer diameter too big |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Canadian Dodge ¾T APT | Danny Croone | The Softskin Forum | 20 | 20-08-19 16:49 |
Sold: Canadian Dodge ¾T APT/WP | Danny Croone | For Sale Or Wanted | 0 | 30-12-18 15:53 |
Canadian Dodge, 3 ton 4x2 | Kevin Goodwin | The Softskin Forum | 82 | 23-11-17 22:29 |
Canadian dodge ? | martyn | The Softskin Forum | 16 | 13-02-11 23:52 |
Canadian Dodge 3/4 ton APT | Don Dingwall | Post-war Military Vehicles | 1 | 25-05-05 13:24 |