|
|
#1
17-10-11, 23:59
|
|||
|
|||
C8a front bumper
Gentlemen: On the front bumper of Chev C8A, there are 2 holes, one at either end. Can anyone out there tell me how far in from the end they are and what is the diameter. Imperial measurements, if possible. Many thanks.....Robert
|
|
#2
18-10-11, 15:27
|
|||
|
|||
Clarification
Hi Robert
Wanted to clarify which bumper holes you are speaking about, below is a picture of the end of my 1941 C60L. but I think it is the same. Cheers Phil
__________________
Phil Waterman `41 C60L Pattern 12 `42 C60S Radio Pattern 13 `45 HUP http://canadianmilitarypattern.com/ New e-mail Philip@canadianmilitarypattern.com
|
|
#3
18-10-11, 19:03
|
|||
|
|||
|
bumber holes
they are for "jewel" reflectors, mine are green, and too expensive
|
|
#4
18-10-11, 20:47
|
|||
|
|||
|
C8A Bumper
Hi Phil and Dennis: Thanks for the insite and the quick reply. Phil, the photo you included is the what I'm looking for. My question is ...how far are the holes in from the end of the bumper and what diameter are they?
Dennis, I'll give you a call later in the week about stuff! Cheers....Robert
|
|
#5
18-10-11, 21:38
|
|||
|
|||
|
2 inch hole
Hole is 2 inches diameter with the center of the hole 2 inches in from the end and centered vertically. Bolt hole for the jewel bracket are 3/8" ID and are centered fore and aft on the top and bottom of the bumper and centered to the 2 inch hole.
Hope that helps Phil
__________________
Phil Waterman `41 C60L Pattern 12 `42 C60S Radio Pattern 13 `45 HUP http://canadianmilitarypattern.com/ New e-mail Philip@canadianmilitarypattern.com
|
|
#6
18-10-11, 21:59
|
|||
|
|||
|
Thanks Phil
Phil: Many thanks for the quick reply. Will be working on that over the next couple of days. Will be in touch.....Robert
|
 |
|
|
Linear Mode
