MLU FORUM  

Go Back   MLU FORUM > MILITARY VEHICLES > The Carrier Forum

Notices

Reply
 
Thread Tools Display Modes
  #1  
Old 21-02-10, 12:34
martyn martyn is offline
Registered User
 
Join Date: Feb 2009
Location: lincolnshire
Posts: 135
Default Welded hull

Hello can anyone help

A friend of mine has a welded hull carrier anyone know of any others in the UK or has anyone got any good photos of one, It was a good lower hull and track guards but only had 2inch of top armoure all the way round, he made the sides up but the bulkhead and some bits were a bit of a guess.
After seeing mine hes trying to make it correct but we think this is the only one in the uk that we have found so far.....

martyn
Reply With Quote
  #2  
Old 21-02-10, 12:59
malcolm erik bogaert malcolm erik bogaert is offline
Registered User
 
Join Date: Nov 2006
Location: Berwick on Tweed on the English/Scottish Border.
Posts: 491
Default welded hull

Martyn a picture or 2 might help your cause! regards malcolm
__________________
mally B
Reply With Quote
  #3  
Old 21-02-10, 18:58
RichardT10829's Avatar
RichardT10829 RichardT10829 is offline
Richard Harrison
 
Join Date: Nov 2008
Location: Cullercoats Newcastle Upon Tyne United Kingdom
Posts: 3,059
Default

Martyn i thought that later mk2's and mk3's were all welded tubs ? i would have thought these would be more prevelant than mk1's, just goes to show


Rich
__________________
is mos redintegro

__5th Div___46th Div__
1942 Ford Universal Carrier No.3 MkI*
Lower Hull No. 10131
War Department CT54508 (SOLD)
1944 Ford Universal Carrier MkII* (under restoration).
1944 Morris C8 radio body (under restoration).
Reply With Quote
  #4  
Old 21-02-10, 22:40
martyn martyn is offline
Registered User
 
Join Date: Feb 2009
Location: lincolnshire
Posts: 135
Default

any photos would be helpfull, I will take some photos of his when i next see it.
this one was cut down and used as a pumping station in a quary, it looks like a mk1 from the rear as it has the two holes near the diff but its welded? nice to see a welded one after only reading about them
Reply With Quote
  #5  
Old 22-02-10, 00:45
Lynn Eades Lynn Eades is offline
Bluebell
 
Join Date: May 2003
Location: Tauranga, New Zealand
Posts: 5,534
Default Martyn

What is the removeable front plate(glasis plate) like?
Attached Thumbnails
ford 004.jpg   OP hull.jpg  
__________________
Bluebell

Carrier Armoured O.P. No1 Mk3 W. T84991
Carrier Bren No2.Mk.I. NewZealand Railways. NZR.6.
Dodge WC55. 37mm Gun Motor Carriage M6
Jeep Mb #135668
So many questions....
Reply With Quote
  #6  
Old 23-02-10, 17:26
martyn martyn is offline
Registered User
 
Join Date: Feb 2009
Location: lincolnshire
Posts: 135
Default

Hi Thanks for the photo the front plate i think is the same as that in the photos but carnt be sure as not had a propper look at it whats the bulkhead and look like and the air boxes as these are the parts we are looking to get made again to be more inkeeping, at the moment there is no engine covers and air boxes on her

thanks for the photos any more would be a great help
cheers martyn
Reply With Quote
  #7  
Old 24-02-10, 01:32
Lynn Eades Lynn Eades is offline
Bluebell
 
Join Date: May 2003
Location: Tauranga, New Zealand
Posts: 5,534
Default Martyn

If its the same, it never had any air ducts She's an AOP No? MkIIIw, Built by Ford at Dagenham, probably. I would love to see any details of her. Is there a "T" number, or ID plate?
I am looking for the details of the observers (gunners) shutter. the plate, the profile etc of the frame/guides, Locking mechanism, and the handle. Cheers.
__________________
Bluebell

Carrier Armoured O.P. No1 Mk3 W. T84991
Carrier Bren No2.Mk.I. NewZealand Railways. NZR.6.
Dodge WC55. 37mm Gun Motor Carriage M6
Jeep Mb #135668
So many questions....
Reply With Quote
  #8  
Old 28-02-10, 15:45
martyn martyn is offline
Registered User
 
Join Date: Feb 2009
Location: lincolnshire
Posts: 135
Default

Hi Lynn
this carrier had been cut off two inches above the welds around the side armour couldnt tell you if it was a op or not, my friend is trying to find a few photos of it when he got it as a pumping rig.
At the moment my friend has just built it back up as best he could to get it to look like a carrier. as soon as get back to see it will see if any numbers have been stamped on anywhere ?
Reply With Quote
  #9  
Old 01-03-10, 22:08
carrierbarry carrierbarry is offline
Barry
 
Join Date: Apr 2007
Location: Watford, London
Posts: 215
Talking carrier remains?

Hi Martyn
A few years ago I found the remains of a carrier still being used in a quarry as a pump. The armour had been cut and a big water pump was instaled. The cement works still used this machine daily until about 2006. It was yellow and had the British worsley wheels ( round holes ). If this is the same carrier I have a video and some stills. I'll dig them out.

Barry
Reply With Quote
  #10  
Old 01-03-10, 23:25
martyn martyn is offline
Registered User
 
Join Date: Feb 2009
Location: lincolnshire
Posts: 135
Default

Hi Barry
i know the one my friend had it too that was a mk2 he sold it and now its in a very poor state now it fell in to the hands of a carrier wantabe how should i say he F@*ked it about not knowing what he was doing, he thort a carrier was just a box on tracks and an easy project but unlike a jeep you carnt just pick up the phone and order the parts or scank other peoples take off parts. it would still make a nice carrier but would need all new frame, floor, and bulkhead he cut them all out with out taking any measurements then sold it to another chap i have found it again the chap who purchased my 2nd carrier has it iam thinking of asking if he wants me to restore it back to a propper hull for him. will take some photos of it when i nxt go over to see him.
Anyway if your in lincoln or near by drop in i owe you a carrier drive hahahaha been a long time since beltring mate lol
Reply With Quote
  #11  
Old 01-03-10, 23:41
kevin powles's Avatar
kevin powles kevin powles is offline
Registered User
 
Join Date: May 2006
Location: united kingdom
Posts: 1,955
Default

Hi Martyn, That Carrier photo CD I sent you last year had some pics of a restored welded hull carrier on it, I remember seeing this odd looking carrier on a model making picture reference site. I posted you convoy bracket today.

Kevin.
__________________
2pdr Tank Hunter Universal Carrier 1942 registered 11/11/2008.
3" Mortar Universal Carrier 1943 registered 06/06/2009.
1941 Standard Mk1 stowage Carrier, Caunter camo.
1941 Standard Mk1 stowage Carrier, light stone.
10 cwt wartime mortar trailer.
1943 Mk2 Daimler Dingo.
1943 Willys MB.
1936 Vickers MG carrier No1 Mk1 CMM 985.
Reply With Quote
  #12  
Old 02-03-10, 00:26
martyn martyn is offline
Registered User
 
Join Date: Feb 2009
Location: lincolnshire
Posts: 135
Default

Hi Kevin
Thanks for that if you need anything else just ask if i have it you are welcome to borrow it, also thanks for reminding me about the cd forgot all about it will have a look at it tomorrow.
Reply With Quote
  #13  
Old 15-03-10, 00:34
martyn martyn is offline
Registered User
 
Join Date: Feb 2009
Location: lincolnshire
Posts: 135
Default confused?

ok now iam getting confused whats the diffrance between a mk1 no 2 and a mk1 no 3 welded hull, is a mk2 the same as a rivetted carrier with airboxes or or not could any one shed some light on this looked in nigels book not a lot of help on this one
Reply With Quote
  #14  
Old 15-03-10, 01:18
Lynn Eades Lynn Eades is offline
Bluebell
 
Join Date: May 2003
Location: Tauranga, New Zealand
Posts: 5,534
Default Martyn

The No.1, No2, No3. all refer to the size/model of Ford V8 motor.
I believe the Mark III refers to the Welded hull construction ( and the associated changes i.e. air ducting) introduced at the same time.
The Armoured O.P.(observation post)MarkIII, was by October 1942,identified as being an incorrect nomenclature, and was re designated as;
Armoured O.P. No. 1, Mark III (W)
they are essentially the same shape as a rivetted hull Mk1 (Same sand guards. No side steps,but altered to suit the A.O.P. role)
__________________
Bluebell

Carrier Armoured O.P. No1 Mk3 W. T84991
Carrier Bren No2.Mk.I. NewZealand Railways. NZR.6.
Dodge WC55. 37mm Gun Motor Carriage M6
Jeep Mb #135668
So many questions....

Last edited by Lynn Eades; 15-03-10 at 01:35. Reason: more info
Reply With Quote
  #15  
Old 15-03-10, 13:02
martyn martyn is offline
Registered User
 
Join Date: Feb 2009
Location: lincolnshire
Posts: 135
Default

Hi Lynn
thanks for that, things have started to make sence now.
Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT +2. The time now is 19:00.


Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright © Maple Leaf Up, 2003-2016