|
|
#1
02-01-14, 01:09
|
|||
|
|||
12v to 6v conversion for Cab 12
I just put in a 12v to 6v electronic voltage reducer and regulator. This unit was purchased on ebay and will enable you to use any load such as gauges , lights or anything else up to 20 amp with a constant regulation of 6.8 volts. I installed this on my oil pressure guage and my fuel tank gauges and they work perfectly. I could also hook up some dash board lights etc as long a s I switch them on a different circuit than the 12v headlights. This system works better than putting in resistors. Please excuse the wiring mess as I have to tuck everything into looms
Terry 
|
|
#2
02-01-14, 03:58
|
|||
|
|||
|
Fantastic job.....
You should have been a brain surgeon....
Nice job. Bob C
__________________
Bob Carriere....B.T.B C15a Cab 11 Hammond, Ontario Canada
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Interesting carrier conversion ?? | ron | The Carrier Forum | 17 | 01-03-11 06:49 |
| Chev 1 1/2 ton winch conversion | DanJahn | The Softskin Forum | 1 | 07-02-11 16:23 |
| Conversion Alternator Brackets | RHClarke | The Restoration Forum | 10 | 19-03-09 02:50 |
| 235-261 Conversion Information | Phil Waterman | The Restoration Forum | 1 | 02-03-09 22:13 |
| Aussie Twin cab CMP conversion | Keith Webb | The Softskin Forum | 1 | 18-09-03 23:32 |
Linear Mode
